6. Remove the screw shown in callout 3, and then remove the fuser power supply cover.
Figure 6-73.
Removing and replacing the fuser power supply PCB (1 of 2)
7. Remove the two screws shown in callout 4.
8. Using needle-nose pliers, remove the four clips shown in callout 5.
9. Disconnect the four connectors shown in callout 6, and remove the fuser power supply
PCB.
Figure 6-74.
Removing and replacing the fuser power supply PCB (2 of 2)
Fuser drive unit
Use the following steps to remove the fuser drive unit.
240 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...