To remove the fuser inlet paper sensor
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Remove the fuser. See
Replacing the fuser.
5. Disconnect the connector shown in callout 1.
6. Unhook the two tabs that are closest to the connector, shown in callout 2.
7. Remove the fuser paper sensor.
Figure 6-79.
Removing and replacing the fuser paper sensor
Fuser delivery sensor and output bin full sensor
Use the following steps to remove the fuser delivery sensor and the output bin full sensor.
To remove the fuser delivery sensor and output bin full sensor
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Remove the fuser. See
Replacing the fuser.
5. Remove the screw shown in callout 1.
6. Unhook the tab on the side of the sensor cover shown in callout 2.
244 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...