7. Remove the sensor cover shown in callout 3.
Figure 6-80.
Removing and replacing the fuser delivery sensor and output bin full sensor (1 of 2)
8. For the fuser delivery sensor, disconnect the connector shown in callout 4, unhook the
two tabs that are closest to the connector, and remove the fuser delivery sensor, shown
in callout 5.
9. For the output bin full sensor, disconnect the connector shown in callout 6, unhook the
two tabs that are closest to the connector, and remove the output bin full sensor, shown
in callout 7.
Figure 6-81.
Removing and replacing the fuser delivery sensor and output bin full sensor (2 of 2)
ENWW Internal components (top) 245
To Next Page
Loading...