5. Remove the width detection switch, shown in callout 3, by pushing it into the cassette
cavity.
Figure 6-94.
Removing and replacing the paper feeder length and width detection switches
Paper feeder pickup clutch
Use the following steps to remove the paper feeder pickup clutch.
To remove the paper feeder pickup clutch
1. Remove the paper feeder left cover. See Paper feeder left cover.
2. Disconnect the connector shown in callout 1.
3. Remove the three screws shown in callout 2, and remove the pickup motor mount.
4. Disconnect the connector shown in callout 3, and remove the pickup clutch (callout 4).
Figure 6-95.
Removing and replacing the paper feeder pickup clutch
ENWW Optional 500-sheet paper feeder 255
To Next Page
Loading...