3. Remove the six screws shown in callout 2, and pull out the lifter drive unit.
Figure 6-93.
Removing and replacing the paper feeder lifter drive unit
Paper feeder length and width detection switches
The paper length and width detection switches are located on the left side of the paper
feeder, next to the paper feeder PCB. The length detection switch is towards the rear of the
paper feeder, and the width detection switch is toward the front.
To remove the paper feeder length and width detection switches
1. Remove the paper feeder left cover. See Paper feeder left cover.
2. Disconnect the connectors shown in callout 1.
3. Unhook the tabs on either side of both switches.
4. Remove the length detection switch, shown in callout 2, by pushing it into the cassette
cavity.
254 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...