3. Use the guide pins on the printer stand to align the 500-sheet paper feeder as you lower
it onto the printer stand.
4. Insert an attachment screw into each of the four alignment holes. Using your fingers or a
coin, tighten the screws to attach the printer to the 500-sheet paper feeder.
Note
This is true for each device sheet feeder and/or a printer stand.
5. Gently lower the printer onto the 500-sheet paper feeder.
CAUTION
Avoid bending the guide pins while lowering the printer.
Note
The above graphic represents the HP Color LaserJet 5500hdn model. The HP Color
LaserJet 5550hdn has three 500-sheet stackable sheet feeders.
Installing a new overlay (HP Color LaserJet 5500 models)
Some printer models are shipped without the control panel overlay installed or you might
prefer using a different overlay from the one that is installed. Overlays are available for
several languages. If you are setting up a printer for a language other than English, follow
this procedure.
1. Open the top cover. Use a small flat-blade screw driver to release the locking tabs on
either side of the control-panel overlay, and then remove the overlay.
66 Chapter 3 Installation and configuration ENWW
To Next Page
Loading...