2. Position the new overlay over the top of the control panel. Insert the left tab of the
overlay into the slot on the printer face. Line up the tab on the right side of the overlay
with the slot on the right side of the control panel. Set the overlay in place by pushing
down on the overlay near the blue button.
Control panel and overlay for HP Color LaserJet 5500 models only
3. Press
to open the MENUS.
4. Press
to highlight CONFIGURE DEVICE.
5. Press
to select CONFIGURE DEVICE.
6. Press
to highlight SYSTEM SETUP.
7. Press
to select SYSTEM SETUP.
8. Press
to highlightLANGUAGE.
9. Press
to select LANGUAGE.
10. Press
to highlight the desired language, and then press to select and save the
language choice.
Installing a new control panel label (HP Color LaserJet 5550
models)
Some printer models are shipped without the control panel labels installed or you might
prefer to use a different label than the one that is installed. Labels are available for several
languages. If you are setting up a printer for a language other than English, follow this
procedure.
1. Remove the backing from the adhesive side of the label.
2. Position the new label over the top of the control panel.
3. Press the label firmly onto the control panel.
Note
When applying the label, start at the center and press the label into place towards the edges
of the control panel.
ENWW Installing print cartridges for HP Color LaserJet 5500 series printers 67
To Next Page
Loading...