18 Chapter 2 - Removal and replacement Q1342-90910
Left side cover
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
2 Open the toner cartridge door.
3 Remove the single left-cover retaining screw (callout 1).
4 Pull out on the rear of the cover and rotate it away from the
printer.
Figure 7. Remove the left side cover
Hint It might be necessary to release the left side cover-locking tab found
under the printer.
Hint The left-side retaining screw is slightly longer than similar screws used
in the printer. Keep this screw separated from other screws while
servicing the printer to avoid misplacing it.
11
To Next Page
Loading...