42 Chapter 2 - Removal and replacement Q1342-90910
Fuser assembly
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side, back, right side, and top covers. See “Left side cover”
on page 18 through “Top cover” on page 29.
2 Remove two screws (callout 1) from the right fuser bracket.
3 Remove a third screw (callout 2) from behind the large gear on
the right fuser plate. Rotate the gear counter clockwise to align a
hole in the gear with the screw-head.
4 Remove the bracket.
Figure 31. Remove the right fuser bracket
2
2
1
2
To Next Page
Loading...