Q1342-90910 Internal assemblies 41
4 Release the two shutter-retaining tabs (callout 3) and remove the
shutter and shutter spring.
CAUTION Use care when releasing the shutter-retaining tabs. The tabs are plastic
and can be broken. Only bend the tabs enough to release the shutter
lever.
5 Remove the four screws (callout 4) that fasten the scanner to the
printer chassis and remove the laser/scanner.
Figure 30. Remove the laser/scanner
CAUTION When replacing the laser/scanner, verify that it is fully seated on the
printer chassis. The laser/scanner can be damaged when the mounting
screws are tightened if it is not fully seated.
Hint Insert the spring into the hole on the laser/scanner before you snap the
shutter lever back into place.
3
44
3
To Next Page
Loading...