48 Chapter 2 - Removal and replacement Q1342-90910
Right plate assembly
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side, back, right side, and top covers. See “Left side cover”
on page 18 through “Top cover” on page 29.
z Unlace the solenoid wire harness. See “Solenoid” on page 27.
z Front cover, toner cartridge door, and front guide. See “Front
cover” on page 32 through “Front guide” on page 36.
z Fuser assembly. See “Fuser assembly” on page 42.
2 Lift the small white tab to release the clutch, and slide the clutch
to the left (toward the pickup roller).
Hint Keep the two halves of the clutch gear together to avoid losing the
internal clutch spring.
Figure 37. Remove the gear-clutch assembly
To Next Page
Loading...