Q1342-90910 Internal assemblies 53
Pickup roller assembly
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side, back, right side, and top covers. See “Left side cover”
on page 18 through “Top cover” on page 29.
z Front cover, toner cartridge door, and front guide. See “Front
cover” on page 32 through “Front guide” on page 36.
z Fuser assembly. See “Fuser assembly” on page 42.
z Right plate assembly, and pickup assembly. See “Right plate
assembly” on page 48 through “Pickup assembly” on page 50.
2 Release the locking tab on the right side pickup roller cam
(callout 1) and slide the cam to the left about one inch.
3 Slide the roller shaft toward the right until the left end releases.
4 Carefully pull the left end of the shaft toward you until it clears the
left side of the chassis. Remove the pickup roller assembly.
Figure 42. Remove the pickup roller assembly
21
To Next Page
Loading...