54 Chapter 2 - Removal and replacement Q1342-90910
Paper lift plate assembly
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side, back, right side, and top covers. See “Left side cover”
on page 18 through “Top cover” on page 29.
z Front cover, toner cartridge door, and front guide. See “Front
cover” on page 32 through “Front guide” on page 36.
z Fuser assembly. See “Fuser assembly” on page 42.
z Right plate assembly and pickup assembly. See “Right plate
assembly” on page 48 through “Pickup assembly” on page 50.
2 Grasp the large plastic tabs (callout 1) on each side of the paper
lift plate and rotate it forward.
CAUTION To avoid damaging them, do not pull on the paper guides.
3 Lift the paper lift plate up and out of the bushings (callout 2).
Figure 43. Remove the paper lift plate assembly
Hint When replacing the paper lift plate, verify that the lift plate springs
(callout 3) are fully seated onto the circular spring positioning
pedestals.
21
2
3
2
2
To Next Page
Loading...