Q1342-90910 Bottom assemblies 61
5 Apply slight pressure to disengage the paper-feed assembly
bushings from the roller shaft (callout 4). Lift the paper-feed
assembly up and out of the printer.
Figure 50. Remove the paper-feed assembly
Hint When replacing the paper feed assembly, insert the two tabs
(callout 5) on the paper-feed assembly into the provided recesses
(callout 6) near the roller. Insert the bottom of the sensor flag into the
hole in front of the paper-feed roller shaft and verify that the sensor flag
moves freely.
2
2
2
4
5
6
To Next Page
Loading...