Q1342-90910 Errors 73
Toner specks
appear on the
printed page.
.
The media you are using does not meet
HP’s specifications (for example, it is too
moist or too rough).
Make sure that the media meets
specifications detailed in the Print Media
Guide for the HP LaserJet printer family.
The printer needs to be cleaned. Clean the printer. See the
HP LaserJet 1000 Series user guide.
Characters
are only
partially
printed (also
referred to as
dropouts).
A single sheet of paper is defective. Try reprinting the job.
The print density needs to be adjusted. Adjust the print density from the device
configuration utility.
The moisture content of the paper is
inconsistent, or the paper has moist or
wet spots on the surface.
Make sure that the media meets
specifications, detailed in the Print Media
Guide for the HP LaserJet printer family.
The paper was damaged by inconsistent
manufacturing processes.
Make sure that the media meets
specifications detailed in the Print Media
Guide for the HP LaserJet printer family.
A draft mode or EconoMode is selected
in the software.
Clear the printer software EconoMode
check box.
The toner cartridge is defective. Replace the toner cartridge. See “Toner
cartridge” on page 15.
Vertical lines
appear on the
printed page.
The photosensitive drum inside the toner
cartridge is scratched.
Replace the toner cartridge. See “Toner
cartridge” on page 15.
The fuser is damaged or has an
obstruction.
Replace the fuser. See “Fuser assembly”
on page 42.
Table 11. Solving print image-quality problems (continued)
Problem Cause Solution
To Next Page
Loading...