5. Open the print cartridge access door.
6. Remove the front cover.
7. Remove four screws (callout 1, figure 5-27).
1
Figure 5-27. Removing the ECU assembly (3 of 5)
8. Lift the ECU cover up just enough to free it and tilt it back as far as it will easily go.
9. Two sheet metal hook hinges (one on each side) secure the cover.
Figure 5-28. Removing the ECU assembly (4 of 5)
10. Push both hooks free with a screwdriver to remove the ECU cover.
ENWW Internal assemblies 77
To Next Page
Loading...