State of the printer Lights Action
Out of memory - The product is out of
memory.
The page you are printing might be too
complex for the product's memory
capacity. Try lowering the resolution.
Attention state - The print cartridge door
is open, the trays contain no media, no
print cartridge is installed, or media is
jammed.
The printer is in an error state that
requires operator intervention.
Check the following:
■ Make sure that the print cartridge
door is completely closed.
■ Make sure that media is loaded into
the input tray.
■ Make sure that the print cartridge is
correctly installed in the product.
■ Clear any media that is jammed in
the product.
Fatal error - The product is in a
nonrecoverable error state.
Turn off the printer, and then unplug the
printer power cord for 30 minutes. Plug
the printer power cord into the power
outlet, and then turn the printer on.
If the error persists, replace the printer.
See
Printer exchange on page 127.
All lights off Make sure that the power switch is in the
on position.
Make sure that the product is plugged
into a working power receptacle.
Unplug both ends of the power cord, and
then plug the power cord into both the
printer and the power receptacle again.
Table 6-3 Control-panel light patterns (continued)
96 Chapter 6 Troubleshooting ENWW
To Next Page
Loading...