Engine-power assembly
1 Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 68.
● Left-side cover. See
Left-side cover on page 70.
● Top-cover assembly. See
Rear panel and top-cover assembly on page 70.
● Front cover. See
Front cover on page 75.
2 Disconnect the six cables (callout 1) near the top of the power assembly.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always pull
on the plastic body of a connector to avoid damaging the connector wires.
3 Remove four screws (callout 2).
2
1
Figure 5-23 Remove the engine-power assembly (1 of 2)
80 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...