Fuser (fixing) assembly
1 Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 68.
● Left-side cover. See
Left-side cover on page 70.
● Top-cover assembly. See
Rear panel and top-cover assembly on page 70.
2 Disconnect cables, as necessary, from near the top of the engine-power assembly and disconnect
the high-voltage wire (callout 1) from the back of the printer.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always pull
on the plastic body of a connector to avoid damaging the connector wires.
1
Figure 5-25 Remove the fuser (fixing) assembly (1 of 2)
3 Remove the wire harnesses from the plastic harness retainers.
82 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...