Paper-pickup assembly
1 Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 68.
● Left-side cover. See
Left-side cover on page 70.
● Top-cover assembly. See
Rear panel and top-cover assembly on page 70.
● Front cover. See
Front cover on page 75.
● Transfer-roller assembly. See
Transfer-roller assembly on page 77.
● Fuser (fixing) assembly. See
Fuser (fixing) assembly on page 82.
2 Disconnect and unwind any additional wires as necessary to release the paper-pickup assembly.
Unplug and unwind the wire from the solenoid to the formatter.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always pull
on the plastic body of a connector to avoid damaging the connector wires.
3 Remove six screws (callout 1), and then remove the paper-pickup assembly.
1
Figure 5-27 Remove the paper pickup assembly
Reinstallation tip When replacing the paper-pickup assembly, be sure to transfer the
sensor PCB and, if necessary, the separation-pad assembly to the new paper-pickup
assembly.
84 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...