C4170-90959
Service Mode
51
Service Mode
In Service Mode the following can be preformed:
• Print a Service Mode Self-Test.
• Verify and set the page count.
See “Setting the Page Count” (page 53) for information.
• Set the Cold Reset Default.
See “Setting the Cold Reset Default” (page 53) for information.
• Set the Demo Page=True/False
Used to remove the demo page from the service mode self-test.
• Set the Diagnostic Functions On or Off.
For software developers use only.
Accessing Service Mode
Use PJL commands to enter service mode and perform various service mode
configurations. Users must use the exact character and case specified for PCL printer
commands. The following are elements of a typical printer command:
• Escape character (begins escape sequence)
• Parameterized character
• Group character
• Value field (contains both alpha and numeric characters)
• Termination character (uppercase)
Escape sequences may be combined into one escape sequence string. There are three
important rules to follow when combining code:
1 The first two characters after the
E
C
character (the parameterized and group characters)
must be the same in all of the commands to be combined.
2 When combining escape sequences, change the uppercase (termination) character in
each individual escape sequence to lowercase.
3 The final character of the combined escape sequence must be uppercase.
To Next Page
Loading...