Q2431-90912 Chapter 6 Removing and replacing parts 159
CAUTION The product contains components that are sensitive to electrostatic discharge (ESD). Always
perform service work at an ESD-protected workstation.
6. Use your fingers to gently pry the front of the print-cartridge door away from the control-
panel display to release the retainer clip (callout 6). Unplug the control-panel wire-harness
(callout 7). Remove the control panel.
Figure 97. Control-panel assembly (4 of 4)
Reinstall note When the control-panel display is installed, verify that the wire-harness is placed in the cable
guide under the grounding strip.
5
6
6
7
To Next Page
Loading...
