Q2431-90912 Chapter 6 Removing and replacing parts 173
Laser/scanner assembly
1. Remove the following assemblies:
● Top cover. See “Top cover” on page 146.
● Right-side cover. See “Right-side cover” on page 149.
2. Unplug the laser/scanner wire-harness connector from the DC controller PCA (location J84;
callout 1). Remove the laser/scanner wire-harness from the wire guide (callout 2).
Figure 117. Laser/scanner (1 of 4)
3. Unplug the laser/scanner wire-harness (callout 3) from the laser/scanner PCA
Figure 118. Laser/scanner (2 of 4)
2
11
2
43
To Next Page
Loading...
