184 Removing and replacing parts Q2431-90912
4. Unplug the paper-pickup gear assembly solenoid (callout 4) connector from the
DC controller PCA (location J92; callout 5). Unweave the solenoid wire-harness from the
wire guide and the cable clips (callout 6).
Hint It might be necessary to remove additional wire-harnesses from the wire guide to gain access to
the solenoid wire-harness.
Figure 133. Paper-pickup assembly (3 of 5)
5. Remove four screws (callout 7). Reach inside the printer and push the rear tray 2 feed roller
up into its raised position (see “Tray 2 feed rollers (4 of 4)” on page 142). This disengages
the roller lifting arm (callout 8) from the clutch gear.
Figure 134. Paper-pickup assembly (4 of 5)
4
4
5
5
6
4
6
7
7
8
To Next Page
Loading...
