Q2431-90912 Chapter 6 Removing and replacing parts 209
500-sheet feeder lifter-drive assembly
1. Remove the 500-sheet feeder right-side cover. See “500-sheet feeder right-side cover” on
page 204.
2. Unplug the lifter-drive harness connector from the assembly PCA (location J803; callout 1).
Disconnect the tension spring (callout 2) and remove one screw (callout 3).
Figure 171. 500-sheet feeder lifter-drive assembly (1 of 2)
3. Pull the tray lifter-drive assembly out towards the right side of the chassis until its pivot shaft
clears the tray guide. Rotate the lifter-drive assembly up and out of the chassis to remove it.
Figure 172. 500-sheet feeder lifter-drive assembly (2 of 2)
3
2
1
3
2
1
To Next Page
Loading...
