Printer pickup delay jam from tray 1
If the top-of-page sensor (PS103) does not detect the leading edge of the media within a specific
period of time after the media is picked up, the microprocessor on the dc controller PCA determines
that a pickup jam has occurred.
NOTE The printer attempts to pick up the media several times before determining that a
pickup jam exists. The number of pickup attempts depends on the source (for example, four
attempts occur if tray 1 is the source).
The transport process stops and a 13.XX.YY JAM message appears on the control-panel display.
For more information about jam messages, see
Alphabetical printer messages or Numerical printer
messages.
Printer pickup delay jam from tray 2
If the pre-feed sensor (PS102) does not detect the leading edge of the media within a specific period
of time after the media is picked up, the microprocessor on the dc controller PCA determines that a
pickup jam has occurred.
NOTE The printer attempts to pick up the media several times before determining that a
pickup jam exists. The number of pickup attempts depends on the source (for example, four
attempts occur if tray 1 is the source).
The transport process stops and a 13.XX.YY JAM message appears on the control-panel display.
For more information about jam messages, see
Alphabetical printer messages or Numerical printer
messages.
Printer pickup stationary jam
If the top-of-page sensor (PS103) does not detect the trailing edge of the media within a specific
period of time after the media is picked up, the microprocessor on the dc controller PCA determines
that a pickup jam has occurred.
The transport process stops and a 13.XX.YY JAM message appears on the control-panel display.
For more information about jam messages, see
Alphabetical printer messages or Numerical printer
messages.
Printer-delivery wrap jam when feeding regular media
NOTE Regular-size media is defined as A4, Letter, Legal, B5, Executive or A5.
If the fuser delivery sensor (PS108) does not detect the trailing edge of the media after a specified
fusing time, the microprocessor on the dc controller PCA determines that a printer delivery-wrap jam
has occurred.
The transport process stops and a 13.XX.YY JAM message appears on the control-panel display.
For more information about jam messages, see
Alphabetical printer messages or Numerical printer
messages.
Printer delivery wrap-jam when feeding irregular media
NOTE Irregular media is defined as media that is less than 200 mm (7.9 inches) in length.
Paper-pickup-and-feed system 123
To Next Page
Loading...