Tray 1 separation pad
NOTE If the optional envelope feeder is installed, press the release button on its left side
and remove the feeder. Then proceed to step 2.
1 Remove the front accessory cover (not shown). See Accessory covers and the tray 2 extension
door.
2 Insert the tip of a a small flat-blade screwdriver under the tray 1 separation pad.
3 Carefully twist the screwdriver to dislodge the separation pad. Remove the tray 1 separation pad.
Figure 6-9 Tray 1 separation pad
User-replaceable parts 181
To Next Page
Loading...