2 Pinch the blue latch that is on the left side of the roller. Slide the roller off of the shaft (arrows).
Figure 6-11 Tray 2 feed rollers (2 of 4)
CAUTION When you install this roller, make sure that it locks into place. Verify that the
roller is correctly oriented, and that the round, black spacer next to the roller is correctly
positioned against the locking pin on the shaft.
WARNING! Do not allow the front of the printer to extend beyond the edge of the work
surface. The printer can become unbalanced and fall, which can cause damage to the
printer or personal injury to the service technician.
User-replaceable parts 183
To Next Page
Loading...