Tray 1
1 Remove the front cover. See Front cover.
2 Open tray 1.
3 Firmly pull both sides of the tray 1 sensor-arm cover down to release it from the shaft.
Figure 6-28 Tray 1 (1 of 3)
Reinstallation tip After reinstalling the tray 1 sensor-arm cover, verify that the sensor
arms move freely.
Hint Before you complete step 4, examine the position of the return-spring at the right
side of the tray. The return-spring must be positioned correctly upon reinstallation. When
reinstalling the tray 1 paper guide, hook the short end of the return-spring in the small
notch located below the right-side hinge-pin receptacle.
200 6 Removing and replacing parts
To Next Page
Loading...