5 Unplug the control-panel wire-harness (callout 5), gently pry the front of the print-cartridge door
away from the control-panel display to release the retainer clip, and then lift the control panel
(callout 6) out of the top cover.
Reinstallation tip When you reinstall the control-panel display, verify that the wire-harness
is placed in the cable guide under the grounding strip.
Reinstallation tip When you reinstall the grounding strip (callout 5), do not forget to replace
the protective clip. If the grounding strip is installed without the clip, tightening the screw will
damage the grounding strip.
208 6 Removing and replacing parts
To Next Page
Loading...