Reinstallation tip The firmware DIMM must be installed in slot 1 (formatter PCA location J1;
topmost slot).
If you are installing additional DIMMs, the second DIMM must be installed in slot 2 (formatter
location J2; second slot down from the top). If another DIMM is installed, the third DIMM must
be installed in slot 3 (formatter location J3; third slot down from the top). If another DIMM is
installed, the fourth DIMM must be installed in slot 4 (formatter location J4; bottom slot). The
printer will not recognize DIMMs if they are not installed in the correct order.
Formatter assembly
NOTE Print a menu map and a configuration page. See Configuration page. Use the
information on the configuration page to restore any user-set product configuration options
after you install a replacement formatter. If you cannot print a configuration page, ask the
customer for a recent configuration page.
1 Remove the formatter cover. See Formatter cover.
2 Remove two screws (callout 1).
1
Figure 6-37 Formatter assembly (1 of 2)
Main assemblies 211
To Next Page
Loading...