6 Remove one e-clip (callout 4) and the shaft collar (callout 5), and then push the tray drive-gear/
shaft (callout 6) into the tray 2 cavity.
NOTE The large gear inside of the paper-pickup drive assembly is not captive and will
slide off of the shaft and be loose inside the paper-pickup drive assembly (see
Table 6-2
Tray 2 drive gear and shaft).
Figure 6-48 Paper pickup-drive assembly (3 of 5)
7 Lift the tray drive-gear/shaft out of the tray 2 cavity.
224 6 Removing and replacing parts
To Next Page
Loading...