4 Remove the two screws (callout 4) that secure the formatter connector bracket to the chassis.
Unweave the formatter connector wire-harness from the cable guides (callout 5).
NOTE You might have to remove additional wire-harnesses from the wire guide to gain
access to the formatter-connector harness.
Figure 6-55 Dc controller PCA (2 of 5)
CAUTION Do not remove the screws (callout 6) on the interface connector.
Figure 6-56 Dc controller PCA (3 of 5)
232 6 Removing and replacing parts
To Next Page
Loading...