HP LaserJet 4250 - Page 360

Control panel message Description Recommended action
TRAY XX
<TYPE> <SIZE>
To change type
press
alternates with
TRAY XX
<TYPE> <SIZE>
Size detected by tray
The printer is reporting the current
configuration of tray XX. The tray switch is
in the Standard position.
1
To change the media type, press
(S ELECT button). Use (U P A RROW
button) and (D OWN A RROW button) to
scroll to the type, and then press
to
select it.
2 To change the media size to Letter, A4,
Executive, B5 JIS, A5, or Legal, leave
the tray switch in the Standard position
and adjust the media guides to the
correct positions.
3 To change the media size to other
sizes, move the tray switch to Custom,
adjust the paper guides against the
stack, and close the tray.
4
Use
and to scroll to the media
size, and then press
to select it.
Repeat this procedure to select the
media type.
5 If the size that appears on the control-
panel display is incorrect and the tray
paper guides are correctly adjusted,
verify that the media-size sensor
(SW102, SW801, or SW1) for the
indicated tray is operating. See
Printer
switches and sensors, 500-sheet
feeder switches, sensors, solenoids,
and PCAs, or 1,500-sheet feeder
switches, sensors, solenoids,
and PCAs. Verify that the sensor
"fingers" inside the tray are engaging
the tray sensor correctly. See
Tray 2,
500-sheet feeder, and 1,500-sheet
feeder media-size detection.
TRAY XX
<TYPE> <SIZE>
Size specified by user
alternates with
TRAY XX
<TYPE> <SIZE>
To change type
press
The printer is reporting the current
configuration of tray XX. The tray switch is
in the Custom position.
1
To change the media type, press
(
S
ELECT button). Use (U P A RROW
button) and (D OWN A RROW button_ to
scroll to the type, and then press
to
select it.
2 To change the media size to Letter, A4,
Executive, B5 JIS, A5, or Legal, set the
tray switch to the Standard position and
adjust the media guides to the correct
positions.
3 To change the media size to other
sizes, leave the tray switch in the
Custom position, adjust the media
guides against the stack, and close the
tray.
4 Select the Paper Handling menu from
the control panel. Configure the size
and media type for the tray.
Table 7-6 Alphabetical printer messages (continued)
346 7 Troubleshooting