Control panel message Description Recommended action
60.2
printer error
The tray 2 lifter-motor is not functioning. 1 Turn the printer off and then on.
2 If the error persists, turn the printer off.
3 Verify that the tray 2 lifter wire-harness
is full seated in its connector on the
dc controller PCA (location J93).
4 Replace the tray 2 lifter-driver
assembly. See Tray 2 lifter-drive
assembly.
5 Replace the dc controller PCA. See
Dc controller PCA.
60.3
Tray 3 lifter motor failure
The tray 3 lifter-motor is not functioning.
Tray 3 can be a 500-sheet feeder or 1,500-
sheet feeder accessory.
1 Turn the printer off and then on.
2 If the error persists, turn the printer off.
3 Verify that the tray 3 lifter wire-harness
is fully seated in its connector on the
sheet feeder PCA.
4 Replace the tray 3 lifter-driver
assembly. See
500-sheet feeder lifter-
drive assembly or 1,500-sheet feeder
lifter-drive assembly.
5 Replace the tray 3 feeder
controller PCA. See
500-sheet feeder
control PCA or 1,500-sheet feeder
control PCA.
60.4
Tray 4 lifter motor failure
The tray 4 lifter-motor is not functioning.
Tray 4 can be a 500-sheet feeder or 1,500-
sheet feeder accessory.
1 Turn the printer off and then on.
2 If the error persists, turn the printer off.
3 Verify that the tray 4 lifter wire-harness
is fully seated in its connector on the
sheet feeder PCA.
4 Replace the tray 4 lifter assembly. See
500-sheet feeder lifter-drive assembly
or
1,500-sheet feeder lifter-drive
assembly.
5 Replace the tray 4 feeder controller
PCA. See
500-sheet feeder
control PCA or 1,500-sheet feeder
control PCA.
62
NO SYSTEM
To continue turn off then on
No system (firmware image) was found. 1 Turn the printer off and then on.
2 Reseat the firmware DIMM, in slot J1.
See
Firmware DIMM (LJ 4200/4300
only).
3 Replace the firmware DIMM. See
Firmware DIMM (LJ 4200/4300 only).
Table 7-7 Numerical printer messages (continued)
Display-message troubleshooting 361
To Next Page
Loading...