Possible cause Recommended action(s)
The OUTPUT PAPER PATH OPEN message appears on
the control-panel display, but the jam access and stapler unit
doors are closed.
■ The door-open switch (SW1101) is damaged or
defective. See
Stacker and stapler/stacker switches and
sensors. Replace the stacker or stapler/stacker.
■ The stapler/stacker PCA is defective. Replace the
stacker or stapler/stacker.
The optional bin 1 full message appears on the control-
panel display, but bin 1 is empty or not full.
■ The paper-full sensor (PS1106) is damaged or
defective. See
Stacker and stapler/stacker switches and
sensors. Replace the stacker or stapler/stacker.
■ The stapler/stacker PCA is defective. Replace the
stacker or stapler/stacker.
Table 7-45 Component-error troubleshooting (continued)
408 7 Troubleshooting
To Next Page
Loading...