Setting Up Your Printing Solution
Step 1: Installing the HP
LaserJet Toner Cartridge
It is recommended that you use
HP LaserJet toner cartridges. HP has
designed the printer, toner cartridges, and
toner formula to work together to give you
optimal image quality from your printer.
Caution
To prevent damage, do not expose the
toner cartridge to light for more than a few
minutes. For extended periods outside the
printer, place the cartridge in a closed
drawer, return it to the original packaging,
or cover it completely with a cloth.
Note
Save the toner cartridge packaging for
possible cartridge storage and recycling.
1 Open the Printer Door by pulling it
toward you in a forward motion using
both hands.
2 Roll the toner cartridge back and forth
briskly to distribute the toner evenly
inside the cartridge.
3 Grasp the end of the clear sealing
tape on the side of the cartridge and
pull firmly to remove the entire length
of the tape. Once removed, the tape
should measure twice the length of
the toner cartridge or 490 mm (19.3
inches).
4 Hold the cartridge by the handle (so
that the arrows are facing the printer)
and slide it down and back into the
printer. The ends of the cartridge
slide into the black plastic grooves in
the printer. Push it firmly into place
and close the printer door.
Note
If toner gets on your clothing, wipe it off
with a dry cloth and wash clothing in cold
water. Hot water sets toners into fabric.
1-6 Set Up EN
To Next Page
Loading...