HP LaserJet 6L - Installing Software From Disks

Installing Software From Disks
The following section lists several different methods of installation. Use
the method that is appropriate for your computer system.
Standard Installation for Windows 95
This setup installs the HP LaserJet Printer and Companion software for
Windows 95.
1 Click Start, select Shut Down, choose Shut Down the Computer, and
click Yes.
2 Turn off your computer.
3 Turn on your computer and restart Windows 95. The “New Hardware
Found” screen appears.
Note
If your computer does not display the message “New Hardware Found,"
you will need to follow these instructions: 1) Insert disk 1 into Drive A:
(or B:), 2) Select Start, then select Run, 3) Type A:SETUP
(or B:SETUP) and click OK, then 4) Follow the instructions on your
screen.
4 Select “Driver from Disk Provided by Hardware Manufacturer.”
5 Click OK. The “Install From Disk” screen appears.
6 Insert Disk 1 into Drive A: (or B:) and click OK.
7 Follow the instructions on your screen to complete the installation.
8 Remove the disk when the installation is complete.
Standard Installation for Windows 3.1 x
This setup installs the HP LaserJet Printer and Companion software for
Windows 3.1
x .
1 Insert Disk 1 into Drive A: (or B:).
2 Select File from the Program Manager and choose Run.
3 Type A:\SETUP (or B:\SETUP) and click OK.
4 Follow the instructions on your screen to complete the installation.
5 Remove the disk when the installation is complete.
1
Installation
EN Set Up 1-13