Installing Memory Cards (DRAM)
Your HP LaserJet 6L printer is capable of
accepting any 70ns or faster (such as a
50ns), 5V, DRAM memory card meeting
JEIDA specifications.
Hewlett-Packard offers 1-, 2-, and 4-MB
DRAM memory cards.
Note
Some printer drivers have an adjustable
memory setting. After installing or
removing a memory card, this setting may
require an adjustment to reflect the new
memory total.
To install memory cards
1 Unplug the power cord from the
printer.
2 Open the Printer Door, remove the
toner cartridge, and close the Printer
Door. Protect the toner cartridge from
light while working on the printer.
3 Gently tip the printer onto its side so
that the memory cover is on top.
4 Remove the Memory Expansion
Cover by placing a finger through the
hole and pulling away from the printer.
5 Align the memory card with the
corner notch so it is positioned as
shown. Push it firmly into the printer.
Replace the Memory Expansion Cover,
set the printer upright, reinstall the toner
cartridge, load the paper, and plug the
power cord back into the printer.
Print a self-test page to ensure that the
printer recognizes the additional memory
you have added. Your Total Memory in
the “Printer Configuration” section will
show the new memory total.
1-20 Set Up EN
To Next Page
Loading...