HP LaserJet 6L - Using the Direct Copy Feature

Using the Direct Copy Feature
The Direct Copy feature allows you to print single copies of a document
directly from your HP LaserJet Companion to your printer with or without
your computer turned on. To make direct copies, your printer must be
directly connected to your HP LaserJet Companion.
Note
You cannot print direct copies to a network printer. If you do not have a
printer connected to your HP LaserJet Companion, send the document
to your computer and then to the HP LaserJet Companion Copier
software to print from a network printer. For more information on using
the HP LaserJet Companion Copier software, see the “Using the HP
LaserJet Companion Copier Software” section later in this chapter.
Tip
Direct copies are defaulted to print at 300 dots per inch (dpi) as black
and white images (no gray tones). For information on optimizing scan
settings for the item being scanned, see the “Adjusting the Copy and
Scan Quality” section later in this chapter.
To print single copies
1 Raise the paper tray and the paper supports.
2 Place the document face forward and top down in the paper tray, and
adjust the paper edge guides by sliding them to the edges of the
document.
Note
You may need to change the paper size in the printer driver:
In Windows 95, select Start, then choose Settings, Printers, and
Properties. Select Paper and adjust your paper size.
In Windows 3.1x, select Main, then choose Control Panel, Printer, and
Setup. Select Paper and adjust your paper size.
3-2 Using the HP LaserJet Companion EN