HP LaserJet 6L - Adjusting Copy and Scan Quality

Adjusting Copy and Scan Quality
The HP LaserJet Companion Settings utility allows you to control the
quality of the copied and scanned images, including documents copied
by the Direct Copy feature. Perform the following steps before scanning
an item to change the scan mode, brightness, contrast, resolution, and
width of the scanned image.
To change the HP LaserJet Companion Settings
1 Click Settings on the PaperPort screen.
Tip
If the Show Tips box is checked, you can see more information about
each button or selection when you hold the cursor over it.
2 Select the Scan Mode. The window under your choices gives a brief
description of which types of documents are best suited for the mode
you have selected.
Note
If you select Custom mode, Modify, you can change the resolution and
the bit depth to improve image quality. See the “Setting Custom
Resolution and Bit Depth” section later in this chapter for more
information.
3 Drag the Page Width slider or click the arrows to set the width of the
page being scanned. This feature allows you to crop the page before
scanning to reduce extra white space.
4 Drag the Sensitivity slider to adjust the scanner brightness and
contrast. A setting of four reproduces the document’s actual brightness
and contrast. A setting of zero makes the resulting scan darker and
muddier, and a setting of eight is lighter and sharper.
5 Click More to select the length of paper in the printer. This feature tells
the printer when to feed the next sheet of paper.
6 Click Apply to send the settings to the HP LaserJet Companion and
leave the window open.
- Or -
Click OK to send the settings to the HP LaserJet Companion, and close
the window.
Note
Any settings you choose will remain in effect until you change them.
These settings will also be in effect for the Direct Copy feature.
3
Using the Companion
EN Using the HP LaserJet Companion 3-13