CAUTION
To install a self-tapping screw, first turn it
counter-clockwise to align it with the existing
thread pattern, then carefully turn clockwise to
tighten.
Do not over-tighten.
If a self-tapping
screw-hole becomes stripped, repair of the screw-hole
or replacement of the affected assembly is required.
Note
Always remove the toner cartridge and the
paper cassette from the printer before removing
or replacing printer parts.
Required Tools
Refer to page 6-3 of the Combined Service Manual.
A TORX T-10 head screwdriver is needed to remove the formatter
shield.
HP LaserJet 5P/5MP, 6P/6MP Printer Service Supplement
Removal and Replacement
42
To Next Page
Loading...