Print-media specifications
This section contains information about specifications for the quality of print media,
guidelines for print media usage, and guidelines for print media storage.
General guidelines
Some print media might meet all of the guidelines in this manual and still not produce
satisfactory results. This problem might be the result of improper handling, unacceptable
temperature and humidity levels, or other variables over which Hewlett-Packard has no
control.
Before purchasing large quantities of print media, always test a sample and make sure the
that the print media meets the requirements specified in this user guide and in the HP
LaserJet Printer Family Print Media Guide. For ordering information, see
Accessories and
ordering information.
CAUTION
Using print media that does not meet HP specifications can cause problems for the printer,
requiring repair. This repair is not covered by the Hewlett-Packard warranty or service
agreements.
This printer accepts a variety of media, such as cut-sheet paper (including up to 100 percent
recycled-fiber-content paper), envelopes, labels, transparencies, glossy paper, HP LaserJet
Tough paper, and custom-size paper. Properties such as weight, composition, grain, and
moisture content are important factors affecting printer performance and output quality. Print
media that does not meet the guidelines outlined in this manual can cause the following
problems:
● Poor print quality
● Increased jams
● Premature wear on the printer, requiring repair
Paper and print media
Category Specifications
Acid content 5.5 pH to 8.0 pH
Caliper 0.094 to 0.18 mm (3.0 to 7.0 mils)
Curl in ream Flat within 5 mm (0.02 in.)
Cut-edge conditions Cut with sharp blades with no visible fray
Fusing compatibility Must not scorch, melt, offset, or release
hazardous emissions when heated to 210° C
(410° F) for 0.1 second
Grain Long Grain
Moisture content 4 percent to 6 percent by weight
Smoothness 100 to 250 Sheffield
ENWW Print-media specifications 17
To Next Page
Loading...
