Transparencies that are used in the printer must be able to withstand 210° C (410° F), which
is the printer fusing temperature.
CAUTION
To avoid damage to the printer, use only transparencies that are recommended for use in
laser printers. See
Accessories and ordering information.
For more information, see
Printing on transparencies.
Supported media weights and sizes
This section contains information about the sizes, weights, and capacities of paper and other
print media that each tray supports.
Tray 1 specifications
Tray 1
Dimensions
1
Weight
Capacity
2
Paper Minimum: 76 by 127 mm (3
by 5 inches)
60 to 177 g/m
2
(16 to 47 lb) Up to 125 sheets of 75 g/m
2
(20 lb) paper
Maximum: 216 by 356 mm
(8.5 by 14 inches)
Glossy paper Same as the preceding
listed minimum and
maximum sizes.
75 to 120 g/m
2
(20 to 32 lb)
Maximum stack height: 12 mm
(0.47 inches)
HP Cover paper
4
203 g/m
2
(75 lb cover)
50 (typically)
Transparencies and
opaque film
Thickness: 0.10 to 0.13 mm
(3.9 to 5.1 mils)
50 (typically)
Labels
3
Thickness: up to 0.23 mm
(up to 9 mils)
50 (typically)
Envelopes
Up to 90 g/m
2
(16 to 24 lb)
Up to 10
1
The printer supports a wide range of standard and custom sizes of print media. Check the printer driver for
supported sizes.
2
Capacity can vary depending on media weight and thickness, and environmental conditions.
3
Smoothness: 100 to 250 (Sheffield).
4
Hewlett-Packard does not guarantee results when printing with other types of heavy paper.
ENWW Print-media specifications 21
To Next Page
Loading...
