To load optional tray 2
1. Pull optional tray 2 out of the printer and remove any paper.
2. Move the media-width guides to match the size of paper that you are loading. Tray 2
accepts several standard paper sizes.
3. Extend the rear of the tray until the arrow on the markings points to the size that you are
loading.
4. Load the paper. If this is special paper such as letterhead, load it with the side to be
printed on facing down and the top edge toward the front of the tray.
Note
If you are duplexing manually, see Printing on both sides (duplexing manually) for loading
instructions.
30 Chapter 3 Printing tasks ENWW
To Next Page
Loading...
