Networking
This section provides information about using your printer on a network.
●
To configure a network port-connected device configuration (direct mode or peer-to-peer
printing)
●
Supported network protocols
●
TCP/IP configuration
●
Using BOOTP/TFTP
●
Using DHCP
●
To discontinue DHCP configuration
●
Using the printer control panel
●
Using the embedded Web server
NOTE
Configuring TCP/IP settings are complicated and should only be performed by experienced
network administrators. BOOTP will require a (PC, Unix, Linux, and so on.) server to
configure specific TCP/IP settings for the product. DHCP will also require a server, but the
TCP/IP settings will not be fixed for the device. Finally, the manual method to configure
specific TCP/IP settings can be done from the control panel.
ENWW 23
To Next Page
Loading...
