Information tab
The Information pages group consists of the following pages.
● Device Status. This page displays the printer status and shows the life remaining of
HP supplies, with 0% indicating that a supply is empty. The page also shows the type
and size of print media set for each tray.
● Configuration. This page displays the network and product information found on the
printer Configuration page, such as page counts, print settings, and paper options.
● Supplies Status. This page displays the life remaining of HP supplies, with 0%
indicating that a supply is empty. This page also provides supplies part numbers. To
order new supplies, click Order Supplies in the Other Links area on the left side of the
window. To visit any website, you must have Internet access.
● Print Info Pages. This page provides a remote way to print an internal page for a device.
Settings tab
This tab allows you to configure the printer from your computer. The Settings tab can be
password protected. If this printer is networked, always consult with the printer administrator
before changing settings on this tab.
The Settings tab contains the following pages.
● Paper Handling. Configure paper handling settings from this page.
● Printing. Configure the IO Timeout from this page.
● Print Quality. Use this page to configure color calibration and optimize settings.
● Print Density. Use this page to configure print density settings including contrast,
highlights, midtones, and shadows.
● Paper Type Settings. Use this page to configure paper types
● Print Modes. Use this page to configure print mode settings.
● System Setup. Use this page to set up system settings, including jam recovery, auto
continue, display contrast, and device language.
● Service. Use this page to start the cleaning mode and restore factory settings.
Networking tab
This tab allows the network administrator to control network-related settings for the printer
when it is connected to an IP-based network.
● IP Configuration. Use this page to set the IP configuration.
● Advanced. Use this page to enable network features such as SLP Config, DHCP,
BootP, and AutoIP.
● mDNS. Use this page to set the mDNS. Use these settings to turn on or off Rendezvous
discovery.
● SNMP. Use this page to set SNMP protocols.
● Password. Use this page to set or change the Administrator Password.
88 Chapter 7 Managing the printer ENWW
To Next Page
Loading...
