dhcp: The print server will send DHCP requests on the network for dynamic IP
configuration.
auto_ip: The print server will be automatically configured with a unique link-local
address 169.254.x.x.
ip IP address for the print server, in dotted notation. For example:
ip-config manual ip 192.168.45.39
where ip-config specifies manual configuration and ip manually sets the IP address
192.168.45.39 on the print server.
Specifying 0.0.0.0 clears the IP address.
If you exit and save a new IP address, it must be specified on the next Telnet connection.
subnet-mask A value (in dotted notation) that identifies the network and host portions of an IP
address in received messages. For example,
subnet-mask 255.255.255.0
stores the subnet mask value 255.255.255.0 on the print server. The value 0.0.0.0
disables the subnet mask. For more information see
TCP/IP Overview.
default-gw The IP address of a default gateway, in dotted notation. For example,
default-gw 192.168.40.1
assigns 192.168.40.1 as the IP address of the default gateway for the print server.
NOTE If the HP Jetdirect print server is configured by DHCP and you
manually change the subnet mask or the default gateway address, you should
manually change the print server's IP address. This will release the DHCP-
assigned address back to the DHCP IP address pool.
Config Server (Read-only parameter) The IP address of the server (such as a BOOTP or DHCP
server) that last configured the IP address on the HP Jetdirect print server.
TFTP Server (Read-only parameter) The IP address of the TFTP server that provided TFTP
parameters to the HP Jetdirect print server.
TFTP Filename (Read-only parameter) The path and TFTP filename on the TFTP server. For example,
hpnp/printer1.cfg
domain-name
The domain name for the device. For example,
domain-name support.hp.com
assigns support.hp.com as the domain name.
The domain name does not include the host name; it is not the Fully Qualified Domain
Name (such as printer1.support.hp.com).
pri-dns-svr
IP address of the primary DNS (Domain Name System) server.
sec-dns-svr IP address of a secondary DNS server to use if the primary DNS server is unavailable.
pri-wins-svr The IP address of the primary Windows Internet Naming Service (WINS) server, in
dotted notation.
sec-wins-svr The IP address of the secondary Windows Internet Naming Service (WINS) server, in
dotted notation.
Table 3-3 Telnet Commands and Parameters (continued)
32 Chapter 3 TCP/IP Configuration ENWW
To Next Page
Loading...