Main Menu
-------------------------------
1. General Menu
2. TCP/IP Menu...
3. SNMP Menu...
4. Other Settings
5. Support Settings
?. Help
e. Exit Menu
0. Exit Telnet
Enter Selection => 2
TCP/IP - Main Settings
-------------------------------
IP Config Method : USER SPECIFIED
IP Address : 192.168.45.39
Subnet Mask : 255.255.0.0
Default Gateway : 192.168.40.1
Config Server : 192.168.2.21
TFTP Server : 192.168.2.21
TFTP File Name : hpnp/print.cfg
Domain Name : Not Specified
Pri DNS Server : Not Specified
Sec DNS Server : Not Specified
Pri WINS Server : Not Specified
Sec WINS Server : Not Specified
Would you like to change any of the settings? (Y/[N]):Y
Host Name : printer1
TCP/IP Menu
-------------------------------
1. TCP/IP - Main Settings
2. TCP/IP - Print Options
3. TCP/IP - Raw Print Ports
4. TCP/IP - Access Control
5. TCP/IP - Other Settings
6. TCP/IP - Diagnostics
0. Return to Main Menu
Enter Selection => 1
Figure 3-1 Example: Using the Menu Interface
To edit these parameters, enter Y. Use the Backspace key to edit the parameters.
Changes are not saved until you save them when you exit the session.
Using Telnet to Erase the Existing IP Settings
To erase the IP address during a Telnet session, use the following command line entries:
1
Type cold-reset, then press Enter.
2
Type quit, then press Enter to exit Telnet.
3 Power the print server off/on.
NOTE This procedure resets all TCP/IP parameters, but only affects the TCP/IP subsystem.
To reset all parameters to factory default values, refer to
Troubleshooting the HP Jetdirect
Print Server.
40 Chapter 3 TCP/IP Configuration ENWW
To Next Page
Loading...