B The HP Jetdirect Control Panel Menu
HP Jetdirect embedded print servers provide a configuration menu that can be accessed from the
printer's control panel. The keystrokes to access this menu from the printer control panel depend on
the printer. Refer to your printer User guide, or print a control panel menu map, for more information.
The printer's graphical control panel is used to access the Jetdirect print server menu items.
Graphical control panels typically display 18 characters on a line, and as many as four lines at a
time. In addition, scrolling may be supported to allow display of additional lines.
?
On graphical control panels, navigation buttons are used to access HP Jetdirect menu items.
Parameter Descriptions
For a description of menu items and options, see the following table.
Table B-1 HP Jetdirect Control Panel Menu
Menu Item Options Description of settings
TCP/IP
ENABLE ■ ON: Enable the TCP/IP protocol
■ OFF: Disable the TCP/IP protocol
HOST NAME
An alphanumeric string, up to 32 characters, used to identify the
device. This name is listed on the Jetdirect configuration page. The
default host name is NPIxxxxxx, where xxxxxx is the last six digits
of the LAN hardware (MAC) address.
CONFIG METHOD Specifies the method that TCP/IP parameters will be configured on
the Jetdirect print server.
■ BOOTP: Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
■ DHCP: Use DHCP (Dynamic Host Configuration Protocol) for
automatic configuration from a DHCP server. If selected and a
DHCP lease exists, DHCP RELEASE and DHCP RENEW
menus will be available to set DHCP lease options.
ENWW Parameter Descriptions 91
To Next Page
Loading...